Oh, and the perpendicular bisector theorem - the theorem states that if a point is on the perpendicular bisector of a segment, then it is equidistant from the segment's endpoints.

Construct the perpendicular bisector of one side of triangle. Construct the perpendicular bisector of another side. Where they cross is the center of the Circumscribed circle. Place compass on the center point, adjust its length to reach any corner of the …

Beside this, what is floor joist strapping? Strapping on the underside of joists will provide some lateral stability to the joists and prevent twisting, but it does not have much effect on load-sharing. Bridging or blocking is more effective in transferring loads from one structural member to another and thus stiffens the floor, decreasing vibration.

Does the scale read zero, 100 N, or 200 N -- or some other reading? The scale reads the tension in the string. The tension in the string is 100 N. This is the force the string must exert up on either of the 100-N weights at either end of the string.

The answer is not zero as we cannot ignore the existence of forces on the spring balance. The 100 N forces on both ends put up a average force of 100 N ( 100+100/2 ). So it would mark 100 N on the scale. It is a very common mistake to think that the reading would be 200 N ( 100+100 ).

Similarly, you may ask, how does a fuel tank vent work? Fuel Tank Venting. In order to breathe, your tank must have a vent somewhere that will relieve both vacuum and pressure. Gasoline expands in volume as it warms up and shrinks in volume as it cools down. The fuel level of your tank changes throughout the day, even if you are not driving it.

Beside this, how do you move an object to the center in Autocad? Help Select the linework, object or block to center. Click Home tab Modify panel Align drop-down Center. Select an existing edge as an axis, and then specify two points between which to center the object on that axis; or press Enter, and specify any two points between which to center the object.

What is a symmetric relation in SolidWorks? Symmetric. A centerline and two points, lines, arcs, or ellipses. The items remain equidistant from the centerline, on a line perpendicular to the centerline.

Similarly, can you put a mirror over a couch? Mount Mirrors Above the Sofa They reflect light, they open up spaces, and they make rooms look better and larger in general. Above a sofa can be a great place to hang a large mirror, but keep in mind that whenever possible mirrors should be hung across from windows or something else that's visually appealing.

Just convert the arc. In addition to MPEDIT, you can also just use the PEDIT command. If you select a line or an arc, PEDIT will ask you if you want to convert it to a polyline.