One of the most popular mixed-mode tests for composite delamination testing has been the mixed-mode bending (MMB) test developed at NASA Langley by Reeder and Crews (1992) and now an ASTM standard (ASTM 2004). The popularity stems from the ability to vary the mixed-mode ratio (or mixity) over a wide range with a single test apparatus.

A mixed—mode delamination test procedure was developed combining double cantilever beam (DCB) mode I loading and end-notch fixture (ENF) mode II loading on a split unidirectional laminate. By loading with a lever, a single applied load simultaneously produces mode I and mode II bending loads on the specimen.

The mixed-mode bending (MMB) test for delamination toughness was first introduced in 1988. This simple test is a combination of the standard Mode I (opening) test and a Mode II (sliding) test. This MMB test has become widely used in the United States and around the world for mixed-mode toughness measurements.

Mixed Mode Bending (MMB) tests were performed to assess the mechanical behaviour of the joints under different loading conditions. Additionally, numerical analysis using cohesive zone modeling (CZM) was performed using both a honeycomb core with a cohesive layer and the homogenized core with an equivalent cohesive layer.

A mixed-mode delaminatlon test procedure was developed combining double cantilever beam (DCB) mode I loading and end notch flexure (ENF) mode II loading on a split unidirectional laminate. By loading the specimen with a lever, a single applied load simultaneously produces mode I and mode II bending loads on the specimen.

The Use of a Modified Mixed Mode Bending Test for Characterization of Mixed-mode Fracture Behavior of Adhesively Bonded Metal Joints

摘要： 基于经典层合板理论及双线性黏聚区本构关系，建立了含一般分层裂纹层合板的理论模型，对I-Ⅱ混合型弯曲（MMB）断裂试件进行了裂纹扩展理论分析。 提出了一种I-Ⅱ混合型断裂叠加模型，引入I型裂纹分量的刚体转动位移，同时考虑了裂纹长度超过试件半长后中部载荷分量对裂纹扩展的闭合效应，并根据黏聚区力学响应，分段获得了位移函数通解。...

2015年9月29日 · The Mixed Mode Bending test (MMB) is suitable for measuring the interlaminar fracture toughness of composite materials under mixed-mode loading. Data reduction is usually based on the assumptions of Linear Elastic Fracture Mechanics, which are not fulfilled in configurations involving large scale fracture, such as in adhesive joints.

以计算所得的桥联曲线作为输入参数,分别用连接器(Connector)和离散内聚力单元(Cohesive单元)的方法建立有限元模型,模拟缝线增强复合材料层合板的混合模式弯曲(MMB,Mix-Mode Bending)试验。

A mixed—mode delamination test procedure was developed combining double cantilever beam (DCB) mode I loading and end-notch fixture (ENF) mode II loading on a split unidirectional laminate. By loading with a lever, a single applied load simultaneously produces mode I and mode II bending loads on the specimen.