Common error codes seen on IGT S+ machines

Forum **Reel Slots** Gaming Machines IGT S2000 and Vision Games. IGT "call attendant" but no error codes 0 Members and 3 Guests are viewing this topic. « previous next »

2013年12月15日 · IGT Red/White/Blue code 65 3 after clear chip/reset I am still learning the basics on slots, and trying to learn this system. I got a IGT R/W/B that was working fine a few months ago, then sat in storage for a couple months. After powering it up after sitting, I got a code 12 (dead batt.). I replaced Batt., then got the dreaded code 61 loop.

Forum **Reel Slots** Gaming Machines IGT S2000 and Vision Games. igt s2000 door closure m and general reel tilt 0 Members and 2 Guests are viewing this topic. « previous next »

2012年2月28日 · Forum **Reel Slots** Gaming Machines IGT S and S-plus Reel Games. (Moderator: knagl) FAQ: IGT S+ Error (Tilt) Codes and Resolutions 0 Members and 1 Guest are viewing this topic. « previous next »

Forum **Reel Slots** Gaming Machines IGT S2000 and Vision Games. IGT S-2000 ERROR (Display's NETPLEX Link is Down) 0 Members and 1 Guest are viewing this topic. « previous next »

2016年12月25日 · is there any easy way to clear this code? i have tried to cycle coins though it but it doesn't seem to wanna clear. i know its a hopper empty code

2008年4月21日 · Error code 61 loop Hi Newbie here. I have an IGT slot that needed the battery replaced. I replaced the battery and got the error 61. I held in the button until it changed to 61 1. I closed the door and hit the key switch. 61 error pop back on. I got on line and order the clear chip. Follow the instructions and the slot did everything n the paper.

2012年2月20日 · I have an igt s+ slot.> When you power it up the top light keeps flashing. If you open and close the door it will stop. When you power it up again same thing. Is there a way to stop it from flashing on power up without taking out the bulb.

2011年6月24日 · Forum **Reel Slots** Gaming Machines IGT S2000 and Vision Games. PRINTER COMMUNICATION FAILURE & DOOR OPEN MB 0 Members and 2 Guests are viewing this topic. « previous next »