2010年2月16日 · Install an hour meter in just a few steps. First, you must select an hour-meter model. Choose your model based on its ruggedness and apparent ease of installation. Having a waterproof hour meter is a plus.

Quick tutorial on how to install an hour meter on any motor that has spark plugs. Thank you for watching, please comment, like and subscribe if you enjoyed! Facebook: / atvcrazy91 Instagram: /...

Using either black or white wire, run a lead from ‘–’ (ground) terminal of gauge to electrical system Ground. When system wiring is complete, connect power and check gauge for proper operation. The hourmeter will advance the right hand digit every six minutes (1/10 Hour). Hourmeter should not advance when ignition switch is off.

Two-terminal hour meters will always record time once power has been applied. For LM Series hour meters with three or four active terminals, enable power on by the positive contact and the device will continuously record. Hour meters with four terminals will become backlit once the backlight terminal con-nects to positive contact. RESETTING THE ...

Connect the hot wire (usually red) on the back of the hour meter to the run wire on the back of the ignition switch, using a Scotch lock wire connector. Attach the ground wire (usually black) on the back of the meter to the boat's grounding system.

Quartz Clock/Engine Hour Meter Installation: 1. Select the location where you will mount the Quartz Clock/Engine Hour Meter, Lay out and mark a center point for the gauge. 2. Cut a 2 1/16" (52mm) diameter hole. Place the Quartz Clock/Engine Hour Meter into its hole to be sure it fits. If the fit is too snug, use a file to slightly enlarge the ...

1. Find a convenient mounting location; be sure the pickup-wire reaches the spark plug wire or plug-in-coil module. Do Not mount meter where surface temperature exceeds 125F. 2. Pull the pickup wire from the bottom of the meter through the pickup hole. Feed the end of the wire down into the adjacent dead end hole and pull tight.

This article aims to provide a detailed wiring diagram for a Curtis hour meter, ensuring correct installation and reliable functionality. The wiring diagram will cover the necessary connections between the hour meter, power source, and the equipment to be monitored.

Hour Meter Tachometer Wiring 1) Always disconnect the ground lead from the vehicle battery before wiring any gauge. 2) Connect a good chassis ground to the Black wire of the gauge harness. 3) Connect switched +12VDC power to the Pink wire of the gauge harness. 4) Connect a tachometer signal to the White wire of the gauge harness: a.

connect the second length of 18-gauge wire to a vehicle circuit where the wire will receive power whenever the ignition key is in any posi-tion except oFF. this wire should also be long enough to reach the hour meter.