2017年10月29日 · Welcome to the Shroomery Message Board! You are experiencing a small sample of what the site has to offer. Pl

2020年7月26日 · I make them. One draw breakthrough in a cartridge like a thc distillate cartridge People often dilute it too much. .7g spice mixed with .3g PG. will fill a 1ml cartridge and potent enough to breakthrough with one long draw. Mix, heat until dissolved. Draw up with a syringe and inject in the cartridge.

2025年1月19日 · Welcome to the Shroomery Message Board! You are experiencing a small sample of what the site has to offer. Please login or register to post messages and view our exclusive members-only con

2017年5月10日 · Basically what you are doing, as I understand it, is acidifying the dmt in the bark using white vinegar which makes it water soluble and pulls it from the bark into the water. Then once the dmt is in the water, you basify it using lye so it then becomes soluble in naphtha, which sucks it out of the water and at the same time converting it to a ...

2015年4月6日 · YOU WILL NOTICE THAT THE DISSOLVED SPICE WILL SEPARATE AND A YELLOW OILY SUBSTANCE WILL SETTLE ON THE BOTTOM, MAINTAINING THE HEAT OF THE HEPTANE WILL HELP THIS SEPARATION OF THE 5-METHOXY-DMT AND THE FREEBASE DMT CONSIDERABLY*** 3. Pipette off the heptane that is clean into a clean …

2009年1月8日 · I then sprinkle some DMT on the top of the brillo (as much as I want to use), and carefully put/stuff the brillo back into the pipe, making sure not to lose any DMT or let it fall off the brillo. The way to use it is by holding the lighter a few inches below the brillo, thereby heating up the brillo, and the DMT that is on top of the brillo ...

2016年7月9日 · Quote: Phinx6236 said: Thanks for the help guys is it better to smoke it or make a ayahuasca analog? honestly I extract either way, smoking in the form of changa is great, but aya or pharma is great too (more trial and eroor with this route though.) dose your maoi about 50 min before dosing dmt for maximum potency. you will go farther with oral in long run, but honestly …

2011年2月12日 · If doing all the steps and re-using the solvent after removing the DMT from it (explained later) the time it takes for 2-3 pulls will leave adequate time for the freebasing of the DMT by the lime for each pull. The 2-3 pulls plus a final pull 24 hours or more later should be enough to get 85%-90% of the DMT.

2019年11月7日 · Hey y'all! I used to lurk on the shroomery about 10 years ago. Anyway, I'm back! I keep hearing about DMT vape pen cartridges and I have also heard that a lot of these vape pens don't get hot enough

2011年2月15日 · Copied thread from Ethnobotanicals: Hi, everyone- here is the situation with my first extraction: Around 5am today it had been around 72 hours of the Naptha/DMT freeze.