ASTM F468 - Standard Specification for Non Ferrous Bolts, Hex Cap Screws and Stud Bolts for General Application.

2023年2月22日 · Standard Specification for Nonferrous Bolts, Hex Cap Screws, Socket Head Cap Screws, and Studs for General Use. 12.1 For purposes of determining compliance with the specified limits for requirements of the properties listed in this specification, an observed value or calculated value shall be rounded in accordance with Practice E29.

This standard is issued under the fixed designation F468; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval.

1.1 This specification covers the requirements for commercial wrought nonferrous bolts, hex cap screws, and studs 0.250 to 1.500 in. and in., socket head cap screws (including socket head cap, button head and flat countersunk head configurations) with nominal thread 0.06 (size 0) through 1.500 in. and low head socket cap screws with nominal thre...

2023年5月6日 · 1 This speci®cation is under the jurisdiction of ASTM Committee F16 on Fasteners and is the direct responsibility of Subcommittee F16.04 on Nonferrous Fasteners. Current edition approved Nov. 1, 2022. Published February 2023. Originally approved in 1976. Last previous edition approved in 2016 as F468±16 1. DOI: 10.1520/F0468-22.

2023年6月1日 · Applicable nuts for use with bolts, cap screws, and studs covered by this specification are covered by Specification F467. The values stated in inch-pound units are to be regarded as standard. No other units of measurement are included in this standard.

1 This specification is under the jurisdiction of ASTM Committee F16 on Fasteners and is the direct responsibility of Subcommittee F16.04 on Nonferrous Fasteners. Current edition approved June 1, 2012. Published November 2012. Originally approved in 1976. Last previous edition approved in 2010 as F468 –10. DOI: 10.1520/F0468-12.

ASTM F468 UNS N06625 represents grade specification for Inconel 625 Bolts, Screw Fasteners. It covers both coarse and fine threaded Alloy 625 Bolts, screws, stud bolts. Below is the chemical, mechanical and other requirements.

1.1 This specification covers the requirements for commercial wrought nonferrous bolts, hex cap screws, and studs 0.250 to 1.500 in. and socket head cap screws (including socket head cap, button head and flat countersunk head configurations) with nominal thread 0.06 (size 0) through 1.500 in. inclusive in diameter manufactured from a number of a...

1.1 This specification covers the requirements for commercial wrought nonferrous bolts, hex cap screws, and studs 0.250 to 1.500 in. inclusive in diameter manufactured from a number of alloys in common use and intended for general service applications.