2018年7月20日 · Rust is ferric oxide, the brown flaky stuff. When you remove rust with electricity and a sacrificial anode, you remove all the ferric oxide (brown rust) and cannot remove the ferrous oxide (black) that way, you brush it off. When gunsmiths blue a gun, they let the iron coat itself with ferrous which prevents rust (ferric).

2021年7月30日 · Removing rust is always labour intensive. After rust is removed wash , blow dry and warm with a propane torch and paint of choice. It is better to do this job in less humidity. If your car rust bleeding on the body or any part use a small brush and wash paint until all rust is washed away.Very safe to use.

2013年6月12日 · As others have said, '0000' steel wool is effective on rusty chrome. I use WD-40 as a lubricant for the steel wool (the equivalent of wet sanding) for an extra margin of safety against scratches. Wipe off the excess WD-40 afterwards and it …

2019年3月2日 · The rust iron atoms are "chelated", meaning they are taken into solution inside another molecule and thus come out when you drain the system. If you want to do it in the garage without the engine running, you will need pipework, a water heater and a pump and expect to leave it running for at least a fortnight.

2024年11月15日 · For dusty/dirty items a liquid solution may be better like rubbing alcohol (70% or stronger), WD-40, acetone (nail polish) and perhaps something like Goo Gone might do the trick. HOWEVER, some salvage yards use PAINT PENs which may require using solvents geared towards paint thinning and removal..

2025年1月4日 · The distributor springs can be carefully removed from the posts to allow the weights to be removed and cleaned. I would just clean them (use solvent like WD-40 and steel wool. The springs look OK and can be reused. I bought these mufflers to replace the non-original ones on my '67.

2021年12月1日 · Then clean any residue off (as much as possible) and put some form of a lubricant (oil/Marvel/WD-40) into the cylinders and rotate the engine in order to spread the lubricant in the cylinders. As far as cleaning the block I …

2017年10月12日 · You could plug in your wired connectors, then spray inside the socket with WD-40 or PAM cooking spray- then carefully pipe in a "harder" silicone, such as Ultra black or Ultra blue, or a "bathroom type" caulking, let it harden, then carefully pull it out, to make a plug.

2013年8月30日 · Maybe then helps press Air out from a long tubed Airpistol and WD 40 also with a long Tube on it. Good luck to your Son ;-) Sorry Tom i told you wrong things,there wasnt a cable,i looked at my 38 and its only blocked on driverside with the knob about a lever to a rail with teeth,you can see it when you look from driverside under the bench.

2015年8月20日 · I use the WD 40 on my engine compartments. If you want to get into the true feel of a 1920's car owner put a little kerosene and a corn cob in a two quart bucket. Give 'er the once over every Saturday morning. It might be a little dusty for that fish fry on Friday night, but it will look great in the church parking lot on Sunday.