Your Mercedes-Benz hood latch may get stuck or stuck due to a lack of lubrication. That is why it is important to keep the dirt off the hood latch and the hood release cable. The latch can get sticky due to dust, dirt, and rust.

DIY Instructions on how to change hood lift support (gas struts) on a Mercedes-Benz car. If the hood does not stay open it can be a safety concern if you need to do any maintenance on your engine such as check fluid levels or do an oil change.

2017年11月30日 · Learn how to open a stuck Mercedes-Benz hood latch without any tools! In this video, I'll share a simple trick to fix the issue, avoid costly repairs, and ge...

It seems like you're experiencing issues with the hood release on your Mercedes. Here are a few video tutorials that can help you diagnose and fix the problem: Mercedes Benz Hood Lever Repair (Fix) - This video provides a step-by-step guide on how to repair a faulty hood lever.

2010年7月16日 · After replacing the idler pulley for the serpentine belt last week, I tried to open my hood... and it won't release. To be more specific, the right hand (passenger) side wont release. I had to pull the upper radiator support off to get to the idler pulley and I must have messed something up putting it back together.

Home > Mercedes-Benz Hood Stuck Problems, Tips, Tricks and SOLUTION > location of hood latch stuck mechanism

Procedure for opening the hood latch of most mid-2000's Mercedes hood latch if the cable or latch release mechanism is damaged. This particular video is of a W211 (E-Class) but the principle...

2006年12月11日 · I'm back on the road again but noticed that the hood on the right side doesn't latch securely all the way. Wind gets under the hood lifting it about 1/2" above the other side. I sprayed the upper and lower mechanisms with WD-40, and that didn't seem to help.

2007年10月30日 · I talk from experience, my cable was stuck, and instead of replacing it immediately, I went about opening the hood quite a while without it. I have a new one, by the way . Here's what to do: get the largest and longest flathead screwdriver that you …

2022年11月24日 · For some reason, the link (from the pull-out handle to the latch) was not fully retracked after the hood was closed. This prevented the little flat metal spring from being pushed against the micro switch. As a result, the micro switch sent a signal to the SAM "open hood." The solution is to replace the linkage.