2019年8月30日 · This video covers the installation of roller lifters, roller rockers, and pushrods. It also covers how to align the rocker arms and set up pushrod guide plat...

INSTALLATION Preparation for Installation 1. Remove rocker arms from packaging material. Handle with care to avoid dropping. 2. Using a lint free cloth and lacquer thinner, thoroughly clean rockers to remove rust preventative oil. 3. Do not immerse or wash the rockers in a solvent tank. 4. Inspect rocker shafts, valve tips, pushrod, rocker ...

Now that the cylinder heads are on, it's time to install the push rods, rocker arms, and pedestals. The torque spec for the rocker arm bolts is 25 ft. Lbs.

2019年9月17日 · In today’s video, our friend Eric the Car Guy will show you how install roller lifters, roller rockers, and pushrods on a small block Chevy engine. The principals for installing and setting up these parts apply to other engines too, Eric says.

Stud Rocker Arm System Installation: Step 1:After removing the rockers and other components from the package, thoroughly wash each piece with solvent and then blow dry. Step 2:Prior to installation, submerge the rockers in engine oil for approximately 30 minutes to insure the roller tip and fulcrum are properly lubricated. Step 3: Install the ...

PQx OEM Pedestal Stand Rocker Arm System Preparation: Please read these instructions carefully before beginning your installation. Also, take a moment to review the

INSTALLING ROCKER ARMS IN ENGINES WITH BRIDGE-MOUNTED ROCKER ARMS If your rocker arms are bridge-mounted in pairs, you will need to rotate the engine until both valves are closed, during the compres-sion stroke. You can now install your new rocker arms. Install the rocker arms one cylinder at a time, and then check the lifter pre-load.

Install one rocker arm at a time by inserting the 5/16" bolt through the top of the rocker arm, MAKING SURE THAT THE FLAT SIDE OF THE FULCRUM IS FACING THE BOLT HEAD.After this is

Place an adjustable pushrod checker into the lifter and install the rocker arm assemblies; one intake and one exhaust. Be sure the cam is rotated to the base circle. Seat the bottom of the adjuster screw up against the recess in the rocker arm and turn the adjuster screw clockwise 1 to 1 1/2 turns down. This is the initial adjuster position.

Speedmaster Aluminum Shaft-Mount Rocker Arms offer a sturdier solution for higher RPM. Suitable for street, strip, and track applications. Ensure that the supplied product is suitable for the intended application. Professional installation by a qualified technician.